![]() The Main Power Switch Is Turned OffĪfter making sure the kill switch is OK, it’s time to inspect the battery. The grease will prevent future corrosion. Turn the switch on and off repeatedly until it hopefully starts working again.įor a longer-lasting repair, you must disassemble the switch, clean the insides properly, and then pack it with dielectric grease. If the stitch is not severely corroded, you may get it working again by flushing it with some anti-corrosive like WD-40 or an electric cleaner. Suck corrosion will prevent a proper connection. The Kill Switch Is Corroded or Full of DirtĪnother possible issue with the kill switch is internal corrosion due to water getting inside.ĭirty water in reaction with air will cause green oxide to form on the switch’s metal components. If you’re lucky, setting the kill switch to “run” is all it takes to fix your issue. It is easy to accidentally bump over the switch or forget that it was activated the last time you stopped the ATV. Therefore we tend to forget to check the kill switch’s position when facing issues such as loss of power. Many don’t use their kill switch that often and usually leave it in the “run” position. When the kill switch is in the “stop” position, it cuts all electric power to most systems on the ATV. The Kill Switch Is in the “OFF” PositionĪlways begin by eliminating the quick and easy stuff first. Here are the most common causes to look into when your ATV is not getting any power: 1. No lights, no power to the display, or no power at the ignition. You turn the key or activate the starter button on your ATV, but nothing happens.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |